|
BEATRUSH Rear Bulk Head Division Plate 2003+ Evolution 8-9 CT9A
|
|
BEATRUSH 1-Pc. Front Strut Tower Bar 2003~ Evolution 8-9 CT9A
|
|
Price: $182.00
|
|
|
|
Price: $303.00
|
|
|
|
|
|
The Beatrush rear division panel is useful for track cars with roll cages. It provides a clean interior look and partition from trunk equipment for safety.
|
This product unites the strut towers and creates a balance between the shocks; preventing the shocks from independently moving and causing small changes in suspension geometry. Overall better handling will be felt during cornering.
|
|
|
|
BEATRUSH 1-Pc. Rear Strut Tower Bar 2003~ Evolution 8-9 CT9A
|
|
BEATRUSH License Plate Holder 2003~ Evolution 9 CT9A
|
|
Price: $194.00
|
|
|
|
Price: $49.00
|
|
|
|
|
|
This product unites the strut towers and creates a balance between the shocks; preventing the shocks from independently moving and causing small changes in suspension geometry. Overall better handling will be felt during cornering.
|
Made for Japanese license plates; requires drilling on license plate.
|
|
|
|
BEATRUSH Race Engine Mount Set 2003~ Evolution 8-9 CT9A
|
|
BEATRUSH Engine Roll Stopper 2003~ Evolution 8-9 CT9A
|
|
Price: $507.00
|
|
|
|
Price: $166.00
|
|
|
|
|
Reduces excessive motion of your motor during hard acceleration, deceleration, and cornering; increasing torque efficiency and improving on & off throttle response.
**These engine mount inserts are to be used for race only; they are super stiff.**
|
Reduces excessive motion of your motor during hard acceleration, deceleration, and cornering; increasing torque efficiency and improving on & off throttle response.
|
|
|
|
BEATRUSH Exhaust Manifold Cover 2003~ Evolution 8-9 CT9A
|
|
BEATRUSH Radiator Cooling Panel 2003~ Evolution 8-9 CT9A
|
|
Price: $153.00
|
|
|
|
Price: $122.00
|
|
|
|
|
|
The BEATRUSH Exhaust Manifold Cover for 2003+ EVO 8-9 CT9A will provide the same heat shield protection as the stock piece. However, the Beatrush will not rust like the OEM piece. Not to mention your engine bay will look a lot cleaner.
|
Developed for the purpose of increasing cooling efficiency of the radiator by closing gaps in the engine bay allowing more cooler direct air to be absorbed.
|
|
|
|
BEATRUSH Aluminum UnderPanel 2003~ Evolution 8-9 CT9A
|
|
BEATRUSH Rear Differential Mt. Spacer 2003~ Evolution 8-9 CT9A
|
|
Price: $348.00
|
|
|
|
Price: $65.00
|
|
|
|
|
|
Increases downforce & reduces air turbulance.
|
|
|
|
|
BEATRUSH Propeller Shaft Mt. Bushings 2003-2010 Evolution 8,9,10
|
|
BEATRUSH Shift Control Bushings 2003~ Evolution 8-9 CT9A
|
|
Price: $71.00
|
|
|
|
Price: $71.00
|
|
|
|
|
Replaces stock rubber bushings with solid 2017 aircraft aluminum ones specially designed to prevent the propeller shaft from moving during acceleration/ deceleration. Increases acceleration and reduces wheel hop, while maintaining smooth traction feel.
**Note: Don't fall for the cheap billet imitations that will warp from stress caused by the drive shaft. You're better of staying with the rubber OEM piece that will at least maintain its form.
|
Beatrush's shift control bushings are engineered to improve shift feel and responsiveness on your vehicle by eliminating the soft rubber factory bushings. The shift control bushings remove all flexing common to soft rubber bushings which lead to miss-shifts and sloppy shift feel. Beatrush's shift control busings use polyurathane w/ aluminum inserts to prevent wear and deterioration over the years, thisprovids a confortable yet precise shift feel for daily driving.
|
|
|
|
BEATRUSH 2pnt. Front Strut Bar [38mm] 2003~ Evolution 8-9 CT9A
|
|
BEATRUSH Floor Performance Bar 2003~ Evolution 8-9 CT9A
|
|
Price: $254.00
|
|
|
|
Price: $193.00
|
|
|
|
|
|
This product unites the strut towers and creates a balance between the shocks; preventing the shocks from independently moving and causing small changes in suspension geometry. Overall better handling will be felt during cornering.
|
Reinforces mid pillars of chassis. Creates chassis rigidity similar to a 4pnt roll cage without the roll cage bulk.
|
|
|
|
BEATRUSH Front Strut Tower Bar 2003~ Evolution 8-9 CT9A
|
|
BEATRUSH Rear Strut Tower Bar 2003~ Evolution 8-9 CT9A
|
|
Price: $303.00
|
|
|
|
Price: $194.00
|
|
|
|
|
|
This product unites the strut towers and creates a balance between the shocks; preventing the shocks from independently moving and causing small changes in suspension geometry. Overall better handling will be felt during cornering.
|
This product unites the strut towers and creates a balance between the shocks; preventing the shocks from independently moving and causing small changes in suspension geometry. Overall better handling will be felt during cornering.
|
|
|
|
BEATRUSH Front Performance Bar 2003~ Evolution 8-9 CT9A
|
|
BEATRUSH Front Member Support Bar 2003~ Evolution 8-9 CT9A
|
|
Price: $240.00
|
|
|
|
Price: $132.00
|
|
|
|
|
Even the most powerful car can not perform at a high level without sufficient body rigidity. The Beatrush Performance Bar restrains suspension links and other installation points to enhance rigidity, which make the suspension movement smooth and enhances steering response as well as traction.
Chassis rigidity is improve rapidly. Prevents chassis distortion due to heavy competition. Suspension feeling is improve and sharper turnings are acquired.
|
|
|
|
|
BUDDY CLUB D1 Damper Kit 2003~ Evolution 8, 9 CT9A
|
|
BUDDY CLUB Racing Spec Damper Kit 2003~ Evolution 8, 9 CT9A
|
List: $1,350.00
Price: $1,147.50
|
|
|
List: $1,780.00
Price: $1,513.00
|
|
|
|
|
|
|
|
|
|
